Slick Lock 97+ Chevy GMC Swing Door Lock Kit ‎GM-FVK-1-TK

---

Product Overview

FITS: 

• Chevy & GMC Full Size vans 1997 and newer with hinged rear & side doors

STEP 1 Begin by applying a spray lubricant to back side threads of bolts
holding left rear lock striker plate in place. Using the T40 star socket
remove striker plate, discard shims. Hold GM1A-Rear Left bracket over two
striker plate holes. Reinstall left side striker plate and bolts on top of
GM1A-Rear Left bracket. Hold bracket firm against body of door and retighten
star bit bolts.

STEP 2 Using T27 star bit socket remove two latch bolts from
right rear door leave 3rd screw in place to hold latch in place. Weather
stripping on rear right door will need to be sliced through with a sharp
utility knife. Hold right rear door bracket up against screw holes and mark
weather stripping from top to bottom in location where bracket passes through.

 Cut rubber completely through along retaining strip. Then cut another 1/8 inch
away from retaining strip and discard piece. Install right rear bracket
through weather stripping. Reinstall two 6mm star head bolts using T27 socket.
Only hand-tighten this side. CAUTION – Slowly close left then right door
making sure weather stripping clears left bracket.

Once doors are closed,
align lock holes with RD Pin – (dowel pin, drill bit, etc. ) When you are
satisfied with alignment, slowly open right side door and torque down both
bolts. Shut rear door firmly. If lock fits nicely move on to side doors for
installation of brackets using same process.

If lock is difficult to slide on
and off or difficult to close –Realign right side until desired fit is
achieved – brackets can also be modified with round file or drilling center
hole to accommodate various lock brands. Be careful to not damage your
vehicles painted finish.